Multistage – High pressure centrifugal pump WKL 50

Description

Multistage – High pressure centrifugal pump WKL 50

High pressure centrifugal pump wkl 50 has a suction chamber and thrust chamber and a number of floor chambers. The floors are connected to each other by floor screws.

Inside each chamber there is a diffuser (guide blades). The base of the bearing is closed to the thrust chamber with a flange and two-headed screws. Each chamber is sealed with paper washers or O-rings.
The pump bases are integrally cast with the body of the suction chamber and the thrust chamber, which are placed at the two ends of the pump.

The axle is protected against the flow of corrosive liquids by distance bushings and bushings on the axis. All propellers are placed on the axis in one direction and are connected to the axis by thorns. The distance bushings and the bushings on the axis are also connected to the axis by a flat bar.

We recommend that these pumps be used for pumping clean fluids that do not have abrasive materials and solid particles, and fluids that do not cause chemical or mechanical corrosion in pump parts.

The composition and type of shaft sealing depends on the operating temperature of the pump.

Application of high pressure pump

The WKL 50 high pressure pump is used to increase the fluid pressure in situations where the height or area is high, or the floor high pressure pump (WKL) is used to transfer fluids to a high height.

And in industries, it is used to make water supply pump boosters for rain and drip irrigation, boiler feeding pump, fire fighting, providing drinking water for cities, etc. and it is produced and supplied in two types, horizontal and vertical.

Technical specifications of WKL floor high pressure pump

Output diameter: 32 to 150 mm

Watering: 2 to 440 cubic meters per hour

Height or head: up to 300 meters

Pressure: up to 40 bar