Polyethylene interface 16 mm

Description

Polyethylene interface 16 mm

Polyethylene interface 16 mm One of the drip fittings is the 16 mm interface that is embedded to connect the two drip pipes and is in the category of drip connections.The use of this product is also very common in agriculture.In some cases the water pressure is high, clips on each side of the interface should be used to do not separate the water pressure of the interface from the pipe. These connections are produced and supplied from the working pressure of 4 atmospheres.The interface of 16 polyethylene is one of the components of polyethylene fittings.It is widely used in greenhouse systems, irrigation and agricultural systems and is resistant to heat and cooling, eating and decay. Installation is very easy and easy

Advantages of drip fittings

The use of drip fittings is done with high speed without the need for polyethylene welding machine. In addition, polyethylene fittings can be replaced in case of very simple damage. Drip fittings are used according to the manufacturer’s standard and do not leak and perforate. These joints are very safe and resistant to cracking, pressure and failure

They have a fundamental resistance to chemicals such as acids and base. They are also resistant to wear. In addition to the high quality of products among competitors, the price is lower and more cost effective.

Advantages of 16 to 16 drop interface:

1- Pressure and impact resistant
2- Bulge on both sides of the interface to prevent the pipe coming out and the direction of sealing
3- Resistant to the sun’s rays
4- Resistant to atmospheric conditions of heat and cold

5- Very fast weight and easy transportation
6- Very cheap and affordable price
7- Ability to install by hand without the need for tools
8- Easy sealing without the need for special glue